For horizontal seams under .5″

Use the S-5-E and crimp the seam to 180 degrees at desired clamp location.
For horizontal seams under .5″ you may also use the S-5-T or the S-5-S to avoid crimping the seam.
For horizontal seams greater than .5″ and less than .625″ use the S-5-T.
This illustration demonstrates crimping technique, NOT actual location of clamp.
For horizontal seams greater than .65″
For horizontal seams greater than .65″ use the S-5-U in its horizontal orientation or use the S-5-H90.
For horizontal seams greater than .65″ but less than .80″ use the S-5-H.
For horizontal seams less than .65″ you may also crimp the seam as shown above for the S-5-E.
BE SURE TO LOOK THROUGH & READ SOME OF OUR OTHER HELPFUL FAQ'S REATED TO OUR PRODUCTS & LET US KNOW IF THEY WERE HELPFUL BY VOTING THUMBS UP OR DOWN.
THANK YOU,
S-5! TECH SUPPORT